Differences

This shows you the differences between two versions of the page.

--- tincvpn_setup [2017/05/13 12:03] – neoon
+++ tincvpn_setup [2020/07/17 08:07] – neoon
@@ Line 4: / Line 4: @@
 **Server 1 & 2**
-  apt-get install tinc
+  apt-get install tinc && mkdir /etc/tinc/myVPN
-  mkdir /etc/tinc/myVPN
-Add myVPN into /etc/tinc/nets.boot below
+Add
+  myVPN
+into /etc/tinc/nets.boot below
   ## This file contains all names of the networks to be started on system startup.
@@ Line 32: / Line 33: @@
 **Server 1 & 2**
-  mkdir /etc/tinc/myVPN/hosts
+  mkdir /etc/tinc/myVPN/hosts && cd /etc/tinc/myVPN/hosts
-  cd /etc/tinc/myVPN/hosts
 **Server 1**
@@ Line 50: / Line 50: @@
   tincd -n myVPN -K4096
-Enter... Enter...\\
+Enter... Enter...
-This generates the public and private key pair
+This generates/attaches the public and private key pair
+Public Key: /etc/myVPN/hosts/Server1/2 \\
+Private Key: /etc/myVPN/rsa_key.priv
+**Server 1**
+Add into /etc/tinc/myVPN/tinc-up
+	#!/bin/sh
+	ifconfig $INTERFACE 10.0.0.1 netmask 255.255.255.0
+**Server 2**
+Add into /etc/tinc/myVPN/tinc-up
+	#!/bin/sh
+	ifconfig $INTERFACE 10.0.0.2 netmask 255.255.255.0
+**Server 1 & 2**
+Add into /etc/tinc/myVPN/tinc-down
+	#!/bin/sh
+	ifconfig $INTERFACE down
+We need to make the scripts executable
+  chmod 755 /etc/tinc/myVPN/tinc-*
+**Server 1** We need to copy the Public keys now, you can use tons of methods for that\\
+For Server 1 we need to copy /etc/tinc/myVPN/hosts/Server1 to Server2, /etc/tinc/myVPN/hosts/Server1
+**Server 2**\\
+For Server 2 we need to copy /etc/tinc/myVPN/hosts/Server2 to Server1, /etc/tinc/myVPN/hosts/Server2
+**Finish**\\
+Since Tinc is in nets.boot you can just reboot your boxes or sudo service tinc start. \\
+For Debian 10 you can use:
+  systemctl enable tinc@myVPN
+  systemctl start tinc@myVPN
+If you have issues, you can debug if tinc is able to open a connection to the other server with
+  sudo tincd -n myVPN -D -d3
+**You need to enable TUN/TAP for OVZ**